I'm not able to get that link to work ???
The drills are easy, just remember to relax during your test and think about what you're doing.
This is NOT the test, but it's a few of the main drills.
Broken down...
LOAD (Assuming a belt rather than a box)
1.) Open the feed cover.
2.) Put the rounds in.
3.) Close the feed cover.
4.) Hold the weapon upright, not canting to the left/right.
READY
1.) Adjust range on C79 optical sight.
2.) Flip out shoulder piece. (Assuming it has one)
3.) Put weapon it in the shoulder.
4.) Cock the weapon. (ALWAYS do this in the shoulder.)
5.) Put the weapon on SAFE.
6.) Shut ejection port cover.
6.) Test and adjust, prepare to fire...
FIRE
1.) Weapon off safe.
2.) Fire.
STOPPAGE - Perform your first IA drill
1.) Cock the weapon (again, in the shoulder)
2.) Put the weapon down.
3.) Open the feed cover.
4.) Sweep the tray, clear the rounds. (I like to open the feed tray and inspect the chamber at this point in time, but that's not part of the test)
5.) Close the feed cover.
6.) Raise the weapon to the shoulder.
7.) Fire. (The weapon should not go off - you essentially unloaded it.)
8.) Lower the weapon.
9.) Open the feed cover.
10.) Put the rounds in.
11.) Close the feed cover.
12.) Raise the weapon to the shoulder.
13.) Cock the weapon.
14.) Re-Aquire target and fire.
Fire a few more rounds, they are sluggish and slow...
STOPPAGE 2 (Perform second IA drill - Gas stoppage.)
1.) Cock the weapon in the shoulder.
2.) Put the weapon on SAFE.
3.) Put the weapon down.
4.) Adjust the gas regulator from "Normal" to "Adverse".
5.) Pick up the weapon, put it back in the shoulder.
6.) Re-Aquire target, take the weapon off SAFE.
7.) Fire.
STOPPAGE 3 (Perform change barrel - also to be done after 2 boxes/400 rounds)
1.) Cock the weapon in the shoulder.
2.) Put the weapon down.
3.) Open the feed cover.
4.) Sweep the rounds.
5.) Close the feed cover.
6.) Raise the weapon to the shoulder.
7.) Re-aquire target and Fire. (Nothing should happen, you just "essentially" performed an unload)
8.) Cock the weapon.
9.) Put it on SAFE.
10.) Put the weapon down.
11.) Remove old barrel, put it aside.
12.) Pick up new barrel, perform 3 point check. (Gas regulator at "Normal", S/N matches, nothing clogging chamber/ bore)
13.) Put the new barrel on - CORRECTLY. make sure you give it a couple of tugs.
14.) Put the weapon back in the shoulder.
15.) Take weapon off SAFE.
16.) Fire. (Nothing should happen, but if you haven't put the barrel on correctly, it will leap off at this point, and you'll fail.)
17.) Put the weapon down.
18.) Open the feed cover.
19.) Put the rounds in.
20.) Close the feed cover.
21.) Put the weapon back in the shoulder.
22.) Cock the weapon.
23.) Re-aquire target and Fire.
STOP
1.) Cock the weapon.
2.) Put it on SAFE.
3.) Put it down.
On "carry on", simply put the weapon back in the shoulder, Re-aquire your target, take the weapon off SAFE and fire.
UNLOAD
1.) Cock the weapon.
2.) Put it down.
3.) Open the feed cover.
4.) Sweep the tray, clear the rounds.
5.) Close the feed cover.
6.) Raise the weapon to the shoulder.
7.) Re-Aquire target and Fire. (Nothing should happen)
8.) Put the weapon down.
9.) Close ejection port cover, lower the shoulder piece, put gas regulator back to normal, and reset the C79.
It's a little hard to envision without the weapon BEING here, but I don't think I've missed anything safety related....if I have, mods, please edit.
Cheers and good luck.