• Thanks for stopping by. Logging in to a registered account will remove all generic ads. Please reach out with any questions or concerns.

MTR2000 Programming Cable

Bert

Sr. Member
Reaction score
4
Points
230
I've found myself in austere places and for some reason always need to build an MTR2000 programming cable (computer to radio). Locating tech documentation can be a challenge.  For you deployable comms guys, this document provides the basic information.  See Figure 1.

http://www.safetran.com/product/pdfs/bulletin/pib5-02.pdf

Also if I have to build one again, I'll know where to look for this link.
 
Sweet. I'll pass this on to the Tels Maint shop.

I've had to replicate one in the past from the one we found in a toolbox...
 
Good find Rheo.  Its true, Invensys/Safe Tran have dropped their service bulletin
PIB5-02 MTR2000 Code Plug Configuration document (01-16-03) as the Motorola
MTR2000 has been discontinued for some time.

I have a copy of the PIB5-02 document but the useful info was:

RSS PROGRAMMING CABLE
RADIO SIDE to COMPUTER SIDE

RJ45-M pin 5 (GND) to DB9-F pin 5 (GND).
RJ45-M pin 6 (TXD) to DB9-F pin 2 (RXD).
RJ45-M pin 7 (RXD) to DB9-F pin 3 (TXD).

Pin 1 of the RJ45-M is referenced on the left side of the plug with pin side pointing
up and facing the observer.



 
Back
Top